The control desk/hand support is a fast exchangeable model.
When the sleeves have been fixed the two supports only have to be slipped on and do not require separate screwing.
The two holders, made of aluminium with carbon layer, can be fixed to the sender within a few seconds.
The used materials are aluminium and carbon, attached to each other by means of rustproof screws.
Sender and control desk/hand support have room enough in the Jeti sender bag and it is not necessary to adjust the inside of the bag.
The control desk/hand support is a fast exchangeable model.
When the sleeves have been fixed the two supports only have to be slipped on and do not require separate screwing.
The two holders, made of aluminium with carbon layer, can be fixed to the sender within a few seconds.
The used materials are aluminium and carbon, attached to each other by means of rustproof screws.
Sender and control desk/hand support have room enough in the Jeti sender bag and it is not necessary to adjust the inside of the bag.
The distance support allows adjustment of the distance between body and sender.
Because of the flexible pressure pieces the CFK plate can be pulled out in 20 mm steps, until max. 80 mm, and get positioned. After use the plate can get pushed in with the thumb until the stop and thus disappears below the sender.
Scope of delivery includes an edge protection for the front part of the distance support. If required, it can get mounted.
Same as all other auxiliary parts of mb-modelltechnik, also this type of distance support fits into the sender bag without adjustment of the inside of the bag.
For assembly it is not necessary to make additional holes!
Holders made of CFK can be supplied optionally. The holders get mounted with the flaps to the rear. The advantage to standard holders in combination with the distance support is a slight hanging of the sender to the front. This avoids overstretching of the wrist seen from the ergonomic side and according to information of our test pilots. Many pilots experience the problem of blocking themselves when controlling the flying objects because the wrist points slightly upwards. The holders can also be used without distance support.